Ridgid Conduit And Connection For Hard Wire Installation - Philips Hadco ZoneScape 1-A Documentation

ZoneScape 1-A module documentation
.

Ridgid conduit and connection for hard wire installation

1. Mount the ZoneScape enclosure to a solid surface, utilizing the keyhole slot in the
mounting bracket.
THE ZONESCAPE MUST BE MOUNTED AT LEAST ONE FOOT ABOVE GROUND LEVEL.
2. Before any connections, make sure the transformer is not plugged into an
electrical outlet and that the power switch is in the OFF position.
3. Attach waterproof connectors and conduit using the 7/8" knockouts located on
the bottom of the enclosure.
(All connections to be waterproof. May use waterproof sealant or silicone)
4. Strip approximately 3/8" to 1/2" of the insulation o of each low voltage wire.
5. Push the bare wires under the terminal screws on the terminal blocks and tighten
the screws securely.
Proposal Page 25 of 28