Philips Hadco ZoneScape 1-A Documentation page 18

Configuring more units in the wired system includes connecting to every single unit
to be configured via WiFi and accessing its Web configuration interface for setting up
Network parameters, IP parameters, and Subnet mask.
In order to configure ZoneScape for Wired connection the user needs to access the
following URL in your browser, while connected to the ZoneScape module:
 http://192.168.16.254/home.asp
Once the webpage loads the user needs to select "Operation mode" from the list of
available options as shown in the screenshot below:
The user needs to select "Bridge" mode and click on the "Apply Button" and wait for
around 20 seconds for the module to save settings and reboot. Once done the user
needs to reconnect to the ZoneScape unit and access once again the web
configuration page:
 http://192.168.16.254/home.asp
From the web configuration the user needs to click on "Internet Settings" and then
on "LAN" as shown on the screenshot below:
In our particular configuration we will set ZoneScape with an IP address
192.168.1.254 . This IP address needs to be added in the IP Address field of the LAN
Settings page.
ZoneScape 1-A module documentation
.
Proposal Page 18 of 28