Table of Contents
Advertisement
Step 2:
Locate the two front base channel
sections. Slide the channels against
the spacer and secure with tape.
The template provides the required
31-1/16" interior opening for
installation of the door panel. Check
that the door opening is positioned
correctly for your room and that
there is at least 48" clearance at the
front for a full door swing.
TIP: Locate the door panel. Small
manufacturing variations in the door
panel can result in a poor fit and
cause the door to bind at the top or
bottom when it is opened. Carefully
measure the door opening. Adjust the
opening spacer on the template.
Step 3:
Apply 2 beads of adhesive (supplied
with the wine vault) in the groove on
the bottom of the each base channel
and press into place.
Align the outside edges of the
channels with the marked lines. Make
sure that the mitered corners are
aligned.
Step 4:
Install corner "L" brackets using pop
rivets or sheet metal screws. Secure
the channels to the floor using the
supplied anchors and washers.
Use an anchor on each corner and
one on each side of the door.
Once the base channels have been
secured together and anchored to
the floor, remove any tape.
Step 5:
Install four anchors with washers into
each of the rear and side channels.
9
Advertisement
Table of Contents
