Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
ASSEMBLE WALL AND CEILING PANELS
Installing the Wall Panels
Note: Panels are covered with protective plastic on both sides. Do not remove the plastic
until the panel is ready to be installed.
Step 1:
Separate the panels and locate the
corner panels.
Step 2:
Install one rear corner panel. Use the
supplied hex key to engage the
locking mechanism and secure
the panel to the base channel.
Step 3:
Install a 23" wide panel on the side
and a 46" wide panel at the rear. The
outside surface of the panels should
align with the base channel. Note the
location of the locking access holes.
There are two latches on the right
side of each panel to secure adjacent
panels together and two on the
bottom to secure the wall panels to
the base channels. The top latches
will be used to secure the ceiling panels
to the walls.
Step 4:
Secure the panels together by using
the hex key to lock the latches on the
right side and bottom of each panel.
Step 5:
Carefully tap the panels together
with a rubber mallet to make sure
there are no gaps. Be sure the
adjacent top and side surfaces
are flush.
46" wide
23" wide
panel
panel
Tops and edges
must be flush
11
Advertisement
Table of Contents
