Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
INSTALL THE COOLING UNIT
Apply Foam Insulation Tape
Step 1:
Locate the four pre-cut pieces of black foam insulation tape. There are two long
pieces and two short pieces.
Step 2:
Remove the backing paper from the long
pieces of tape and attach them to the top
and bottom of the cooling unit.
Step 3:
Remove the backing paper from the short
pieces of tape and attach them to the sides
of the cooling unit.
Install the Unit in the Wine Vault
WARNING! The cooling unit is heavy! Two people are required for installation.
Step 1:
From the outside, slide the unit into
the opening in the right front wall.
CAUTION: The opening for the
cooling unit is designed for a tight fit.
Be careful not to bump or damage
the power cord connection when
sliding the unit into the opening.
Step 2:
Use a center punch to mark the
eight mounting holes.
Step 3:
Remove the cooling unit from the
opening. Drill eight 1/8" pilot holes.
Step 4:
Place the cooling unit into the
opening and secure it with the
eight screws provided.
22
Advertisement
Table of Contents
