Entering Settings Through The Local Hmi - ABB REB 551-C3*2.5 Installation And Commissioning Manual

Entering settings through the local HMI

Chapter 9
Setting and configuring the terminal
2 Entering settings through the local HMI
Each of the included functions in the terminal has to be set and this can be performed through
the local HMI. The user must browse to the desired function and enter the appropriate value. The
parameters for each function can be found in the local HMI. See the technical reference manual
for a complete list of setting parameters for each function. Some of the included functions may
not be used. In this case the user can set the parameter "Operation" to "Off" to disable the func-
tion.
Some settings can only be set through the local HMI, such as the setting access, the slave number
and baud rate when communicating with a PC software. The setting access can be blocked by
the binary input signal HMI--BLOCKSET. When this signal is active the user can still read all
information, including the setting values.
65