Table of Contents
Advertisement
3.4
56
Checking the self supervision signals
Procedure
1.
Display the self supervision menu.
Navigate the menus to:
TerminalReport
SelfSuperv
2.
Scroll the supervision values to identify the reason of the failure.
Use the Left and/or Right arrow buttons to scroll between values.
Self supervision HMI data
Table 1:
Output signals for the self supervision function
Indicated result
Possible reason
InternFail = OK
No problem detected.
InternFail = Fail
A failure has occurred.
InternWarning = OK
No problem detected.
InternWarning = Warning A warning has been
issued.
MPM-modFail = OK
No problem detected.
MPM-modFail = Fail
The main processing mod-
ule has failed.
MPM-modWarning = OK
No problem detected.
MPM-modWarning =
There is a problem with:
Warning
•
•
ADC-module = OK
No problem detected.
ADC-module = Fail
The A/D conversion mod-
ule has failed.
Slot04BIM1 = Fail
I/O module has failed.
(Example data, see fol-
lowing section for details)
RealTimeClock = OK
No problem detected.
RealTimeClock = Warn-
The real time clock has
ing
been reset.
TimeSync = OK
No problem detected.
TimeSync = Warning
No time synchronization.
Proposed action
None.
Check the rest of the indicated results to find the
fault.
None.
Check the rest of the indicated results to find the
fault.
None.
Contact your ABB representative for service.
None.
Set the clock.
the real time clock.
If the problem persists, contact your ABB repre-
sentative for service.
the time synchroniza-
tion.
None.
Contact your ABB representative for service.
Check that the I/O module has been configured
and connected to the IOP1- block.
If the problem persists, contact your ABB repre-
sentative for service.
None.
Set the clock.
None.
Check the synchronization source for problems.
If the problem persists, contact your ABB repre-
sentative for service.
Chapter 7
Energising the terminal
Advertisement
Table of Contents
