Kenwood NX-5000 Series Common Function Reference page 357

16 MULTI RF DECK/ MULTI CONTROL HEAD
16.18 Relaying the Received Signal (Mobile Relay Station)
3
Configure the communication port to be used in Mobile Relay Station Mode in
Cable.
Configuration
Cross Cable (Occupy COM port 1)
Custom Cable (Occupy COM
port 2)
4
Write the FPU data.
KPG-D1/ D1N
Common FUNC (K, F)/Ver 2.20
Figure 16-84 Mobile Relay Station DB-25 Cable
Table 16-18 Mobile Relay Station DB-25 Cable
This is the configuration for using a commercially available Null Modem cable.
However, if a commercially available cable is used, an analog channel cannot
be used as a Mobile Relay Channel. Also, the configuration cannot be used
depending on the cable. Use a Null Modem cable of the same wiring as the wiring
diagram in "R COM port 1" of
pin Cable".
This is the configuration for using a self-made cable.
Any of an analog channel, an NXDN channel, and a P25 channel can be used
as a Mobile Relay Channel.
Deck 1
RF
KRK-15B
Control Head
1
Figure 16-85 Triple RF Deck/ Dual Control Head (FPU Setting)
Mobile Relay Station DB-25
Description
"Connecting the RF Deck by Using a D-sub 25-
RF Deck 2 Deck 3
RF
KRK-15B KRK-15B
Control Head
CONTENTS
2
326
INDEX