Operation; Safety Instructions In Operation - Siemens SIMOTICS HV M Operating Instructions Manual

Operation

8.1

Safety instructions in operation

Observe the following when carrying out any work on the machine:
● Comply with the general safety instructions (Page 13)
● Comply with the applicable national and sector-specific regulations at the place of
● When using the machine within the European Union, comply with the specifications laid
Qualified personnel
Ensure that only qualified personnel in the sense of these operating instructions work at the
machine or close to the machine.
Danger as a result of stationary parts under voltage (live parts)
Live parts represent a hazard. Touch protection against active (live) parts is no longer
guaranteed if covers are removed. The minimum air and creepage distances may be fallen
below (violated) when coming close to active parts. Touching or coming close can result in
death, serious injury or material damage.
● Carefully ensure that all of the covers are closed while operational.
● First switch off and disconnect the machine if you must remove covers. Comply with the
● When the machine is in operation, the terminal boxes must remain closed at all times.
Risk of injury due to rotating parts
Rotating parts are dangerous. Touch protection against rotating parts is no longer guaranteed
if covers are removed. Touching rotating parts can result in death, serious injury or material
damage.
● Carefully ensure that all of the covers are closed while operational.
● First switch off and disconnect the machine if you must remove covers. Comply with the
● Only remove the covers when the rotating parts have come to a complete standstill.
SIMOTICS HV M 1RN76308PR900CG0-Z
Operating Instructions 07/2018
installation
down in EN 50110‑1 regarding safe operation of electrical equipment.
"Five safety rules":
Terminal boxes may be opened only when the machine is stopped and in a no-voltage
condition.
"Five safety rules":
8
77