Virtual Inputs - GE 745 TRANSFORMER MANAGEMENT RELAY Instruction Manual

5.5 SETPOINTS S3 LOGIC INPUTS
The Virtual Inputs setpoints are listed below:
S VIRTUAL INPUTS
S [ENTER] for more
S VIRTUAL INPUT 1
S [ENTER] for more
INPUT 1 FUNCTION
Disabled
INPUT 1 TARGET:
Self-Reset
INPUT 1 NAME:
Virtual Input 1
5
INPUT 1 PROGRAMMED
STATE: Not Asserted
5-44
This message indicates the start of the VIRTUAL INPUTS section. To continue
with these setpoints press
section.
This message indicates the start of the virtual input 1 (2-16) setpoints. To
continue with these setpoints, press
the next section.
Range: Disabled / Enabled
Select Enabled if this logic input is to be used. Selecting Disabled will never
allow this logic input to achieve the 'Asserted' (or signaling) state.
Range: None / Latched / Self-Reset
Select None to inhibit the display of the target message when the input is
asserted. Thus an input whose "target type" is None will never disable the
LED self-test feature because can not generate a displayable target
message.
Range: 18 alphanumeric characters
Press to begin editing the name of the virtual input. The text may be
EN TE R
changed from Virtual Input 1 one character at a time, using the
keys. Press
E N TE R
V AL U E
character position.
Range: Not Asserted / Asserted
Select Asserted to place the virtual input in the signaling state. Select Not
Asserted to place the virtual input in the non-signaling state.
745 Transformer Management Relay

5.5.3 VIRTUAL INPUTS

, or press
E N TE R
M E SSA G E
key, or press
EN TE R
to store the edit and advance to the next
GE Power Management
5 SETPOINTS
to go to the next
to go to
M E SSA G E
/
V ALU E