Table of Contents
Advertisement
6 ACTUAL VALUES
6.8 FLASH MESSAGES
Flash messages are warning, error, or general information messages displayed in response to certain key
presses. The length of time these messages remain displayed can be programmed in S1 745 SETUP/PREFER-
ENCES /FLASH MESSAGE TIME. The factory default flash message time is 4 seconds.
SS ADJUSTED VALUE
SS HAS BEEN STORED
SS COMMAND IS BEING
SS EXECUTED
SS DEFAULT MESSAGE
SS HAS BEEN ADDED
SS DEFAULT MESSAGE
SS HAS BEEN REMOVED
SS ENTERED PASSCODE
SS IS INVALID
SS ENTRY MISMATCH –
SS CODE NOT STORED
SS INPUT FUNCTION IS
SS ALREADY ASSIGNED
SS INVALID KEY: MUST
SS BE IN LOCAL MODE
SS NEW PASSCODE HAS
SS BEEN STORED
SS NEW SETPOINT HAS
SS BEEN STORED
SS NO ACTIVE TARGETS
SS (TESTING LEDS)
GE Power Management
This flash message is displayed in response to pressing
setpoint message with a numerical value. The edited value had to be
adjusted to the nearest multiple of the step value before it was stored.
This flash message is displayed in response to executing a command at a
command message. Entering Yes at a command message will display the
message ARE YOU SURE?. Entering Yes again will perform the requested
command, and display this flash message.
This flash message is displayed in response to pressing the decimal key,
followed by
twice, on any setpoint or actual value message except
E N TE R
those in the subgroup S1 745 SETUP / DEFAULT MESSAGES.
This flash message is displayed in response to pressing the decimal key,
followed by
twice, on one of the selected default messages in the
EN TE R
subgroup S1 745 SETUP / DEFAULT MESSAGES.
This flash message is displayed in response to an incorrectly entered
passcode when attempting to enable or disable setpoint access. It is also
displayed when an attempt has been made to upgrade to an option without
the correct passcode.
This flash message is displayed while changing the programmed passcode
from the command message S1 745 SETUP/PASSCODE/CHANGE PASSCODE. If
the passcode entered at the prompt PLEASE RE-ENTER NEW PASSCODE is
different from the one entered at the prompt PLEASE ENTER A NEW PASSCODE ,
the 745 will not store the entered passcode, and display this flash message.
This flash message is displayed under certain conditions when attempting to
assign logic input functions under S3 LOGIC INPUTS. Only the Disabled and To
FlexLogic functions can be assigned to more than one logic input. If an
attempt is made to assign any another function to a logic input when it is
already assigned to another logic input, the assignment will not be made and
this message will be displayed.
This flash message is displayed in response to pressing
745 is in REMOTE mode. The 745 must be put into LOCAL mode in order
for this key to be operational.
This flash message is displayed in response to changing the programmed
passcode from the setpoint S1 745 SETUP/PASSCODE/CHANGE PASSCODE. The
directions to change the passcode were followed correctly, and the new
passcode was stored as entered.
This flash message is displayed in response to pressing
on any setpoint message. The edited value was stored as entered.
This flash message is displayed in response to the
MESSAGE indicator is off. There are no active conditions to display in the
target message queue.
745 Transformer Management Relay
6.8 FLASH MESSAGES
6.8.1 DESCRIPTION
while on a
E N TE R
while the
R E S ET
while editing
E N TE R
key, while the
N EXT
6-23
6
Advertisement
Table of Contents
