Electra Elite Ipk Ii Remote Pc Programming; Remote Programming; Determining Required Equipment - NEC Electra Elite IPK II System Hardware Manual

Document Revision 3
___________________________________________________________________________________
S 5 P
ECTION ROGRAMMING FROM A
Programming can be accomplished using Multiline Terminals equipped with an LCD.
Programming should be used after the system is installed and initial assignments are
made. Using the Multiline Terminal is a quick way to access system data and make
changes. To program from a Multiline Terminal one of the following terminals is
required.
S 6 E
ECTION LECTRA
The Electra Elite IPK II system can be programmed from a remote location using a
personal computer.
6.1
S 7 D
ECTION ETERMINING
To determine equipment type and quantity to be installed, the technician must be
familiar with available station equipment and interface ETUs.
___________________________________________________________________________________
4 - 2
M
DTH-8D-1( ) TEL
DTH-16D-1( ) TEL
DTH-16LD-1( ) TEL
DTH-32D-1( ) TEL
DTR-8D-1( ) TEL
DTR-16D-1( ) TEL
DTR-32D-1( ) TEL
DTP-8D-1 TEL
E IPK II R
LITE EMOTE

Remote Programming

To provide remote programming the following hardware is required:
Internal Modem
MOD-U10 ETU installed on the CPUII( )-U( ) ETU
Available Trunk in the system
LAN Programming
CPUII( )-U( ) ETU
Available Network
R
EQUIRED
T
ULTILINE ERMINAL
DTU-8D-2 TEL
DTP-16D-1 TEL
DTU-16D-2 TEL
DTP-32D-1 TEL
DTU-32D-2 TEL
ITH-8D-2 TEL
ITH-16D-2 TEL
PC P
ROGRAMMING
E
QUIPMENT
Electra Elite IPK II
Hardware Requirements