NEC Electra Elite IPK II System Hardware Manual page 266

Document Revision 3
___________________________________________________________________________________
___________________________________________________________________________________
6 - 124
4. Push the drive in until it is fully seated, as shown in
Flash Drive Seated on VMP( )-U40
Figure 6-69 Flash Drive Seated on VMP( )-U40 ETU
5. Ensure that jumper J1 is set across pins 1 and 2.
6. Ensure that jumper J7 is set across pins 1 and 2.
7. Insert Sony battery CR-2032 into BATT1 connector with the +
sign facing up as shown in
VMP( )-U40 ETU on page
used go to 7.5.5 Installing DSP( )-U30 on VMP( )-U40 ETU on
page 6-129, otherwise your voice mail ETU is ready for
installation.
Electra Elite IPK II
ETU.
Figure 6-69 Flash Drive Seated on
6-124. When an eight port ETU is
Installing ETUs (Circuit Cards)
Figure 6-69