Servicing The Air Cleaner; Servicing The Engine-Oil - Toro Groundsmaster 7210 Series Operator's Manual

Servicing the Air Cleaner

Service Interval: Every 400 hours
Note:
If the foam gasket in the cover is damaged,
replace it.
Important:
Avoid using high-pressure air, which
could force dirt through the filter into the intake
tract.
Important:
Do not clean the used filter to avoid
damage to the filter media.
Important:
Do not use a damaged filter.
Important:
Do not apply pressure to the flexible
center of the filter.
Figure 32

Servicing the Engine-Oil

Checking the Engine-Oil Level
Service Interval: Before each use or daily
The engine is shipped with oil in the crankcase;
however, check the oil level before and after you first
start the engine. Check the oil level before operating
the machine each day or each time you use the
machine.
The crankcase capacity is approximately 3.8
L(4 quarts) with the filter. Use high-quality engine oil
that meets the following specifications:
•
API Classification Level Required: CH-4, CI-4 or
higher.
•
Preferred oil: SAE 15W-40 (above 0°F (-17°C)
•
Alternate oil: SAE 10W-30 or 5W-30 (all
temperatures)
Note:
Toro Premium Engine oil is available from your
distributor in either 15W-40 or 10W-30 viscosity. See
the parts catalog for part numbers.
1. Park the machine on a level surface, lower the
cutting unit, move the throttle lever to the S
position, shut off the engine, and remove the key
from the ignition switch.
2. Open the hood.
3. Remove the dipstick, wipe it clean, install the
dipstick into the tube, and pull it out again.
4. Check the engine-oil level.
If the oil is between the marks on the dipstick
(F of Figure
level. If the oil is below the lower mark on the
dipstick (B of
oil level is between the marks on the dipstick.
g243913
38
33), the engine oil is at a sufficient
Figure 33), add more oil until the
LOW