Set Freq - Mitsubishi Electric MELPRO S Series Operation Manual

4.6.5.

Set FREQ.

There is FREQ. setting for the selecting 50 Hz or 60 Hz.
<NOTE>
Check setting power system frequency before in-service condition.
Turn Switch-3 to FREQ.
(position 10).
The current setting value is
indicated.
This example shows 50Hz as a
setting value.
After showing current setting
value, all LEDs are blinking.
You can select new value
using Switch-4.
After No operation for few
seconds, blinking is stopped.
The indicated value is saved
as a new value.
33 / 47 JEP0-IL9537