4.6.2.
Set Numerical Values
The setting value linked in
Switch-3 position is indicated.
The indicated data is current
setting value.
After showing current setting
value, all LEDs are blinking.
You can select new value
using Switch-4.
Under blinking condition, you
can select a setting value.
After no operation for 2
seconds, blinking is stopped.
The indicated value is saved
as a new setting value.
This new value is enabled for
relay element immediately.
Therefore, in service
condition, DON'T change the
relay setting.
30 / 47
JEP0-IL9537