4.6. Change Relay Element Setting [SETTING]
The new setting of the relay element can be changed by "SETTING" function.
When the password is set, input the password to enter the setting mode.
Go to clause 4.6.1.
When the password isn't set, go to clause 4.6.2 ~ 4.6.8.
4.6.1.
Under Protection by Password
When the password is set, input the password to enter the setting mode.
If using no password, following operation can be passed.
How to set password shows sub-clause 4.6.8.
(1)
Input Password
Set position 7
(Setting)
When the password lock
is enabled, "000" is
indicated.
The blinking LED shows
the operated digit.
You can change the
figure using Switch-4.
27 / 47
JEP0-IL9537