Panasonic LP-GS Series Serial Communication Command Manual page 76

2. When the character arrangement is arc
Name Data length
(> Name in LP-400/V)
Object No.
(> Character
condition No.)
System reserved
value
(> Area No.)
First string No. to
apply
Last string No. to
apply
Character
arrangement
Horizontal and
vertical alignment
Character height
Character width
Center X-position
Center Y-position
Arc radius
Linefeed spacing
Start angle
76
Data contents
[byte]
2 "01"–"60": Object No. 1001 to 1060
1 "0"–"9", "A"–"F"
2
"01"–"50": string No. 1 to 50 (for current
file)
"51"–"60": string No. 101 to 110 (for all
files)
2
"3": Arc Outside
1
"4": Arc Inside
"0": Left and first baseline
1 "1": Center and first baseline
"2": Right and first baseline
Model
7
LP-GS051(-L)
LP-GS052
LP-RC350S
7
LP-RF200P
LP-RV200P
8
"-999.999"–"+999.999" [mm]
8
8 "+000.000"–"+999.999" [mm]
Model
LP-GS051(-L)
LP-GS052
7
LP-RC350S
LP-RF200P
LP-RV200P
7 "-180.00"–"+180.00" [°]
ME-LP-GS-SR-COMP-3
This value does not affect the settings
anymore.
• Select the string number from the
• Applies all strings from the first
• Specify the smaller no. to the starting
• To set only one string, set the same
• If the string No. without setting is
With LP-400/V compatible command
mode, the character spacing type of
the arc is always set to "fixed spacing".
The proportional of arc cannot be set
and readout.
• Specifies which point in the
• The horizontal alignment is the base
• With LP-400/V compatible command
Setting range [mm]
"000.100"–"055.000"
To make the characters bold, set the
"000.060"–"030.000" ratio of the character height and width
not to be other than the range from
"000.100"–"085.000"
1/10 to 10.
"000.100"–"090.000"
Specifies coordinates of the center of a
circle to form an arc.
Setting range [mm]
"000.000"–"055.000"
"000.000"–"030.000"
"000.000"–"085.000"
"000.000"–"090.000"
Sets the position specified by the
horizontal alignment to a starting
position, and specifies the angle.
Remarks
preset reference list.
string No. to the last string No. to the
specified object.
row no. than the last string No.
string No. to the first and last string
No.
specified, that string is included in
the marking layout as a blank line.
character strings is the origin for the
character object.
position of the start angle of an arc.
mode, the vertical alignment is
always set to "first baseline".