Canon Finisher-R1 Installation Procedure page 30

Chapter 1
5) Connect the finisher ant the host machine using the interface cable[1].
6) Fix the cable clamp [2] to the host machine, and route the interface cable [1] through it.
When connecting the interface cable, be sure to turn off the host machine and disconnect its power plug from the
power outlet before starting the work. Otherwise, you may suffer an electric shock.
[1]
[2]
F-1-38
<Saddle Finisher-R2>
1) Mount the rear upper cover (small) to the finisher using a screw.
2) Mount the front foot cover [1] using a screw (RS tightening; M3x8) [2].
3) Mount the rear foot cover [3] using a screw (tapping; M4x12) [4].
22