4Checking The Height/Tilt - Canon Finisher-R1 Installation Procedure

Chapter 1
[1]
F-1-27
6) Fix the fixing plate [1] (front) of the host machine
in place to the finisher [3] using a stepped screw [2]
(M4). (The figure shows a Finisher-R1.)
[3]
F-1-28
7) In the case of the Saddle Finisher-R2, close the
16
front cover. In the case of the Finisher-R1, do not
attach the front cover until you have adjusted the
height/tilt.
1.3.4 Checking the Height/
Tilt
Depending on the condition of the floor of the site
of installation, you may need to adjust the height or
the tilt of the finisher. A discrepancy in the height
or tilt of the finisher can well lead to frequency
jams. Check the height/tilt as follows, and make
adjustments as necessary. (If you are installing a
puncher unit, be sure to make adjustments by
referring
Procedure.)
1) Check the height of the finisher and its host
machine. Check to make sure that the difference in
height between the top cover of the finisher and the
delivery cover of the host machine is 53±2 mm. Take
measurements at 2 locations at the front and the rear;
then, check to make sure that the difference between
the front and the rear is 1.5 mm or less.
[1]
[2]
to the Puncher Unit
0003-1767
Installation