3Connecting To The Host Machine - Canon Finisher-R1 Installation Procedure

Chapter 1
[1]
[2]
[3]
F-1-21
5) Mount the front fixing plate [1] and the rear fixing
plate [2] using 2 screws each [3] (binding; M4x6).
If you are installing a puncher unit, be sure to
mount the fixing plate that comes with the unit as
instructed in the Puncher Unit Installation
Procedure.
<Finisher-R1>
Use FC5-4196 for both fixing plates [1] and [2].
[2]
[3]
[3]
F-1-22
<Saddle Finisher-R2>
Use FC5-4976 for the fixing plate [1] and FC5-4196
for the fixing plate [2].
14
[1]
[2]
[3]
[3]
F-1-23
1.3.3 Connecting to the
Host Machine
Check to make sure that the host machine is off,
and its power plug is not connected to the power
outlet.
1) Make the connection by matching the pin found on
the fixing plate (rear) of the host machine against the
hole in the finisher.
Check to be sure that there is no gap between the
finisher and its host machine.
[1]
0003-1765