Canon Finisher-R1 Installation Procedure page 15

3) Remove the cushioning material (Styrofoam) from the upper cover.
4) Slightly lift the front and rear casters, and remove the cushioning material (Styrofoam). Be sure to shift up the
finisher by holding the upper left cover [1] (gray area).
The finisher is rather heavy. Be sure to work in a group of 2 persons. Particularly when moving it over a step on
the floor, be sure to take full care not to let it tumble over.
5) Remove the tape used on the outside of the finisher.
6) Remove the cushioning material [1] (Styrofoam) of the tray.
[1]
F-1-6
F-1-7
Chapter 1
7