Commissioning - ABB -free@home SAP/S.3 Product Manual

7

Commissioning

Commissioning of the device is always carried out via the Web-based surface of the System
Access Point. It is assumed that the basic commissioning steps of the overall system have
already been carried out. Knowledge about the Web-based commissioning software of the
System Access Point is assumed.
The System Access Point establishes the connection between the free@home participants and
the smartphone, tablet or PC. The System Access Point is used to identify and program the
participants during commissioning.
Devices which are physically connected to the free@home bus, log themselves automatically
into the System Access Point. They transmit information about their type and supported
functions ().
When energized, wireless devices that have not been programmed are in programming mode
for 30 minutes and can be logged into the system. Programmed devices share information
about their type and supported functions with the System Access Point.
During initial commissioning all devices are given a universal name, e.g. "Sensor/switch
actuator 1/1gang". The installer must assign names that are practical and specific for the
system, e.g. in "Living room ceiling light".
The devices must be parameterised for the use of additional functions.
Note
General information about commissioning and parameterization is available in
the ABB-free@home
Product manual 2CKA001473B9726
®
system manual.
Commissioning
│23