Installation of this unit
≥ Lower the clutch lever with your finger until it reaches
the stopper of the changer unit.
≥ Press the right clutch lever to the outside.
≥ Lower the clutch lever with your finger until it reaches
the stopper of the changer unit.
≥ Both clutch levers have been lowered down.
Appendix
64
5
Check the changer unit installation.
≥ Confirm that a 0.09 mm (0.004q) gap gauge cannot be
inserted between the four changer unit seats at the
front and back and the bottom panel of the Bottom
Module.
You can check the front through the
opening if the seats of the changer unit
are in contact with the bottom panel.
≥ If the 0.09 mm (0.004q) gap gauge can be inserted,
contact the vendor.