Preparation Of The Bottom Module - Panasonic LB-DH7 Series Installation Manual

Installation of this unit

Preparation of the Bottom Module

1
Remove the cushioning pads from the changer
unit.
≥ There are six cushioning pads protecting the changer
unit. Remove all of them.
2
Remove the metal fastening for positioning of
the changer unit.
≥ The changer unit is
secured by a metal
fastening for positioning
during transportation to
restrict movement.
(Two sides: left and
right)
≥ The metal fastening for
positioning will be used
to position the Base
Module. ( 25)
≥ Confirm that there is no
dust or dirt on the
surface of the changer
unit so that foreign
objects do not attach to
the disks while the
system is operating.
≥ Remove any dirt
exceeding 1 mm (0.04q)
in diameter.
Preparatory work for installation
Metal
fastening for
positioning
Remove rubbish
Surface of the changer unit
3
Attach the supplied mounting brackets to the
left and right of the unit.
≥ Each mounting bracket is fastened by two M3 screws
at the 14 mm (0.6q) position. (
Adjust the mounting bracket position as needed.
≥ Check the shape and orientation of the mounting
brackets to attach them correctly.
≥ Match the two locating protrusions on the mounting
bracket with the locating holes on the Bottom Module.
Locating holes
Screw holes
Locating protrusions
4
Remove the bottom panel of the Bottom
Module.
≥ Remove the four screws.
Bottom panel
17
14)
Mounting bracket
Screw holes