Table of Contents
Advertisement
Installation of this unit
≥ Error flow chart
If there was an error in checks in patterns
1 to 3 (gaps of 1.5 mm (0.06q) or more)
1 Release the connection of the gear
rack. (
34)
2 Remove the M5 screws from the two modules.
3 Open the module halfway and pull out.
4 Redo the tasks starting from
"Installing in the rack" (
Gap under 1.5 mm (0.06q)
Use the washers supplied with the Bottom
Module to readjust the front and back of the
module and perform the installation (
that the gap becomes under 1.5 mm (0.06q) .
Installation
25).
OK
Error
ACCEPT
32) so
9
Inspect the rail connection part of the gear rack
on the drawer side.
≥ Use the UD guide check fixture to check the gaps in all
rail connection parts of the gear rack.
UD guide check fixture
≥ Rail check: pattern 1
Gap under 1.0 mm (0.04q)
Put the fixture in the rail connection part
of the gear rack on the drawer side, then
slide from right to left to check.
OK
Under 1.0 mm
(0.04q)
31
Use these parts.
Error
1.0 mm (0.04q) or more
Refer to the
following "Error
flow chart".
Advertisement
Table of Contents
