Table of Contents
Advertisement
Installation of this unit
4
Connect the gear rack on the drawer side.
≥ Push up the protruding part on the bottom panel side
to connect to the gear rack of the Base Module or
Extension Module, tighten the three securing screws.
When tightening the screws, keep pushing up on the
protruding part.
≥ Check the connection of the right gear rack on the
interface side.
If it is difficult to check the interface side, it is possible
to temporarily remove the Control Unit or the Writer
Unit. (
40)
≥ If it is difficult to check directly with eyesight, use an
inspection mirror, etc., to check the connection.
Installation
Protruding part
28
≥ Check the connection of the gear rack on the drawer
side.
If it is difficult to check the drawer side, it is possible to
temporarily remove the Control Unit or the Writer Unit.
(
40)
≥ If it is difficult to check directly with eyesight, use an
inspection mirror, etc., to check the connection.
Advertisement
Table of Contents
