Installing The Appliance In Existing Kitchen Units - Miele KFN 14827 SDE ed/cs-2 Operating And Installation Instructions

Installation
Installing the appliance in
existing kitchen units

If the required ventilation gaps
are not adhered to the compressor
will switch on more often and run for
longer.
This will result in increased energy
consumption and a higher operating
temperature of the compressor. This,
in turn, may cause damage to the
compressor.
It is essential to observe the required
ventilation gaps.
 Top box
 Refrigeration appliance
 Housing unit
 Wall
72
* The appliance depth is increased by
approx. 35 mm for appliances with
wall spacers fitted.
The appliance can be built into a run of
kitchen units and installed directly next
to a kitchen furniture housing unit. The
appliance front must protrude in front of
furniture fronts by at least 34 mm at the
sides and by at least 55 mm in the
middle. This enables the doors to be
opened and shut without being
obstructed. To match the height of the
kitchen units in the run, the appliance
can be fitted with a suitable top box .
When installed next to a wall  a
distance of at least 55 mm must be
maintained on the hinge side between
the wall  and the appliance .
The larger the ventilation gap, the
more economically the compressor
will work.
– A ventilation gap of at least 50 mm
depth must be provided at the back
of the appliance behind the whole
width of the top box for air to
circulate.
– The ventilation gap under the ceiling
must be at least 300 cm
that the warm air can escape
unhindered.
2
to ensure