Plumbing; Pool/Spa Configuration - Hayward OmniLogic Installation Manual

Pool/Spa System Configuration
These systems use a single filter pump and filter. Pool or spa operation is controlled by two 3-way valves (suction and return). Refer to the diagram below.
High Voltage Relays
Filter Pump
Lights
Aux 1
Aux 2
POOL/SPA SUCTION
VALVE
CHECK VALVE
(prevents draining
of raised spas)
MANUAL
VALVE
POOL VACUUM
VALVE
SKIM
MAIN
DRAIN
SUCTION
CLEANER
Some important notes regarding standard Pool/Spa systems:
1. The OmniLogic can be programmed to accommodate spa spillover, if desired.
2. A conventional heater (gas or heat pump) and solar can be used to heat both the pool and the spa.
3. If the chlorinator cell is plumbed prior to the pool/spa return valve, then both the pool and the spa can be chlorinated
4. The water sensor should be installed prior to any heater or solar and will display either the pool or the spa temperature, depending on the current operation
of the pool. The temperature will only be displayed when the filter pump is running.
5. If any water feature or pressure side cleaner boost pumps are used, be sure to enable the "interlock" feature (see CONFIGURATION for details) to ensure
that the pumps operate only when the filter pump is on and the system is in the "pool only" operating mode.
6. The plumbing diagram above is intended to be used as a general guideline and is not a complete plumbing schematic for the pool.
7. The air sensor must be installed if the freeze protection feature is enabled for the filter, valves, chlorinator, other pool functions.
Valve Outputs
Pool/Spa Suction
Pool/Spa Return
Valve 3
Valve 4
SOLAR BOOST
MANUAL
CHECK
VALVE
VALVE
FILTER
FILTER
PUMP
TWO-WAY
VALVE
ENERGY
FILTER
ISOLATED
WATER
FEATURE
PUMP
POOL
ENERGY
SAVER
PRESSURE
CLEANER
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS

Plumbing

SOLAR
TEMPERATURE
SENSOR
PUMP CHECK
VALVE
HEATER
SOLAR
VALVE
HEATER
POOL/SPA
BYPASS
TEMPERATURE
VALVE
SENSOR
(manual)
SPA
BLOWER
SPA JET
PUMP
SPA
POP-UP
OVERFLOW
SPILLOVER
POP-UP
POP-UP
HIGH VOLTAGE
LIGHTS
LOW VOLTAGE
TRANSFORMER
FIBER OPTIC
COLOR WHEEL
LIGHT SOURCE
HEAT
PUMP
FLOW
CELL
SWITCH
POOL/SPA
MANUAL
RETURN
VALVE
VALVE
WATER
FEATURE
VALVE WATER
CHECK
FEATURE
VALVE
PUMP
(prevents draining
of raised spas)
IN-FLOOR
CLEANER
RETURN
JET VALVE
WATER
FEATURE
POP-UP
NON-BOOST
PRESSURE
CLEANER
LIGHTS
POOL SWEEP
BOOST PUMP
PUMP
WATER
FEATURE
PRESSURE
CLEANER
9