Hayward Turbo Cell Configuration Manual

NEW MENU SETTING MAY BE REQUIRED!
The T-CELL-15 and GLX-CELL-15-W are designed for pools up to 40,000 gallons. When
replacing an existing T-CELL-15 or GLX-CELL-15, no re-configuration is neccessary.
Configuration of your controller may be required before using the T-CELL-15 or GLX-CELL-15-W
chlorinator cell. Refer to the information below. Incorrect configuration will cause inaccurate salt
readings, improper operation, and possible system shutdown.
CONFIGURATION is necessary with the following models:
• AQR (Aqua Rite - all 2009 or later) - firmware version 1.5 or later
• AQR-PRO (Aqua Rite Pro)
• PL-P-4 (Pro Logic P4)
• PL-PS-x (Pro Logic PS)
• AQ-LOGIC-P-4 (Pro Logic P4)
• AQ-LOGIC-PS-x (Pro Logic PS)
NO CONFIGURATION is neccessary with the following models:
• AQ-RITE (Aqua Rite - 2008 and earlier) - firmware earlier than version 1.5
• AQ-RITE-XL (Aqua Rite XL)

Connecting to an AQR:

1. Slide the Main Switch to the "Auto" position.
2. Push the Diagnostic button repeatedly until "t-xx" appears on the display ("t-15" is the factory
default). If "t-15" is displayed, skip to step 4.
3. To change cell type, slide the Main Switch from "Auto" to "Super Chlorinate" and back to "Auto".
Repeat this process until the "t-15" is displayed.
4. Push the Diagnostic button to exit.

Connecting to an AQR-PRO:

1. Access the Settings Menu by pushing the "Settings" button.
2. Push ">" until Chlor. Config is displayed, then push "+".
3. Push ">" repeatedly until "Cell Type" is displayed.
4. Push "+" or "-" until "T-CELL-15" is displayed.
5. Exit Settings Menu by pushing the "Info" button.

Connecting to an AQ-LOGIC-P-4, AQ-LOGIC-PS-x, PL-P-4 or PL-PS-x:

1. Enter the Configuration Menu.
2. Push ">" until Chlor. Config is displayed, then push "+".
3. With the Chlorinator Enabled, push ">" repeatedly until "Cell Type" is displayed.
4. Push "+" or "-" until "T-CELL-15" is displayed.
5. Exit Settings Menu by pushing the "Menu" button.
T-CELL-15
GLX-CELL-15-W