Sony D-WAVE Zuma CM Z200 Operating Instructions Manual page 40

Setting the keybeep type [F26]
You can set the beep that sounds when you press a button to either a tone or a click.
Tones sound similar to DTMF tones, and clicks are indicated by single beeps.
1
Turn to select Key Sound from the Sounds menu, then push
The Key Sound menu appears.
2
Turn to select the keybeep type.
You can select tones or clicks.
3
Push to enter the new setting.
The standby display reappears.
Note
DTMF tones are sent to the other party during a call even if you set the keybeep type to
clicks.
Setting the keybeep length [F27]
You can set the length of the beep that sounds when you press a button. This setting
affects both the keybeep feedback and DTMF transmission tones. The phone sends a
short DTMF burst (default) or plays every tone of the DTMF signal as long as the
key is held down.
1
Turn to select Beep Length from the Sounds menu, then push
The Beep Length menu appears.
2
Turn to select the keybeep length.
You can select standard or long.
3
Push to enter the new setting.
The standby display reappears.
5.1_CM_Z200 9
.
.
5.9
6/8/98, 9:28 AM