Receiving Side - Mitsubishi Electric MELSEC iQ-R Series User Manual

6.
Set the network configuration as follows.
[Navigation window]  [Parameter]  [Module Information]  [RJ71EN71]  [Port 1 Module Parameter (Ethernet)] 
[Basic Settings]  [External Device Configuration]
7.
Write the set parameters to the CPU module. Then reset the CPU module or power off and on the system.
[Online]  [Write to PLC]
In this example, default values are used for parameters that are not shown above. For the parameters, refer to
the following.
 MELSEC iQ-R Ethernet User's Manual (Application)

Receiving side

Connect the engineering tool to the CPU module on the receiving side and set the parameters.
1.
Set the CPU module and add a module label of the CPU module. The setting method of the CPU module and addition
method of the module label are the same as those of when setting the sending side. ( Page 69 Sending side)
2.
Set the RJ71EN71 and add the module labels of the RJ7171EN71. The setting method of the RJ71EN71 and addition
method of the module label are the same as those of when setting the sending side. ( Page 69 Sending side)
7 COMMUNICATION EXAMPLES
7.1 Communication Examples of Ethernet
7
71