User Maintenance And Cleaning Instructions; Lint Filter; Sensor - Blomberg DV 17600 W Owner's Manual

7

User maintenance and cleaning instructions

7.1 Lint filter

Lint and fibers released from the laundry
in to the air during the drying cycle are
collected in the "Lint Filter".
C
Fibres and lint are formed during
wearing and washing.
A
WARNING: Always clean the filter
after each drying cycle.
To clean the Filter;
1. Open loading door.
2. Remove the lint filter by pulling it up and
open the filter.
3. Clean lint, fiber, and by hand or with a soft
piece of cloth.
4. Close the filter and put it back in place.
C
You can clean the filter and filter
area with a vacuum cleaner.
C
Clogging may arise on the filter
surface after using your dryer for
some time; if this occurs, wash the
filter with water and dry it before
using again.
22 / EN

7.2 Sensor

There are humidity sensors in your dryer that
detect whether the laundry is dry or not.
For sensor cleaning;
1. Open loading door.
2. Allow dryer to cool off if drying has been
done recently.
3. Wipe the metal sensors with a soft cloth
dampened with vinegar and dry the sensors
afterwards.
C
Clean the metal sensors at regular
intervals (4 times a year).
A
WARNING: Never use solvents,
cleaning agents or similar
substances when cleaning as
these might cause fire and/or an
explosion!
Dryer / User Manual