Fixing Rrh; Fixing Finger Guard; Parts And Tools For Fixing Finger Guard - Samsung RFV01U-D2A Installation Manual

Fixing RRH

This section describes the procedures to fix the system on a wall and a pole.

Fixing Finger Guard

To fix the finger guard, do the following:
1
Table 3. Parts and Tools for fixing Finger Guard
Category
Parts
Recommended Torque Value
Working Tools
Check the type and fixing location of the finger guard before fixing it.
2
RFV01U-D2A Installation Manual v2.0
Copyright © 2017, All Rights Reserved.
Make sure you have the following items:
Description
Finger Guard_Front
Finger Guard_Rear
Finger Guard_Bottom
Fastener
M3 screw
M5 SEMS
 Torque driver (2 to 10 lb·fin and 20 to 90 lbf·in)
 Screw driver bit ('+', No. 2)
 Screw driver ('+', No. 2)
[Finger Guard_Front]
[Finger Guard_Bottom]
Place the finger guard_front to the RRH front.
M3 × 10L screw
M5 × 10L SEMS
[Finger Guard_Rear]
Confidential
Chapter 2 Installing System
1 EA/RRH
1 EA/RRH
1 EA/RRH
4 EA/RRH
12 EA/RRH
5.6 lbf·in (6.4 kgf·cm)
25 lbf·in (29 kgf·cm)
20