Cautions For Installation; Before Installing; While Installing - Samsung RFV01U-D2A Installation Manual

Cautions for Installation

Observe the following safety instructions when installing the system. Installation
should be in accordance with the applicable local electric codes.

Before Installing

Before starting the installation, ensure the following:



Install the system in the Restrict Access Area.

While Installing

While installation, ensure the following:


Make sure the power switch of power supply is off when installing the system.
Installing the system with power switch on may cause system damage or fatal
human injury when cables are not correctly connected.
Make sure that worker wears protection gloves and goggles to prevent damage
from debris while drilling holes in a wall or ceiling.
Do not wear accessories such as watches and rings to prevent electrical shock.
Never allow foreign substances to be inserted into unused ports by covering them
with a cap.
To prevent foreign substances, outdoor air and moisture from entering the cable
inlet (including cable gland and conduit), do the following:
- Unused inlet
Use the hole finishing materials including cap and rubber packing.
- Cable-installed inlet
After cable installation, block any space in the inlet with tape, compressed sponge,
rubber packing, and silicon.
Keep a safe distance between the base station antenna and people.
RFV01U-D2A Installation Manual v2.0
Copyright © 2017, All Rights Reserved.
Post warning signs in areas where high-voltage cables are installed.
Post 'off limit' signs in areas where accidents are most expected.
With guardrails or fences, block open areas such as connecting parts, roof, and
scaffold.
The system power must be cut off before installing.
Be careful not to damage or scratch the boards mounted on the system and the
cables among the boards when the system is transported or installed.
Confidential
Chapter 1 Before Installation
6