Toro Sand Pro 3040 Operator's Manual page 34

•
Faulty charge-relief valve
•
Faulty charge pump
If the cylinder moves in 10 to 15 seconds, proceed to
step 6.
6. Operate the traction pedal in forward and reverse. The
wheels that are off the floor should rotate in the proper
direction.
•
If the wheels rotate in the wrong direction, stop
the engine, remove the lines from the rear of the
pump, and reverse the locations.
•
If the wheels rotate in the proper direction, stop
the engine and adjust the spring-adjusting pin
locknut (Figure 43). Adjust the traction neutral
position; refer to
Neutral (page 29).
3
Figure 43
1. Spring-adjusting pin
2. Bearing
7. Check the adjustment of the traction interlock switch;
refer to Adjusting the Traction Interlock Switch (page
29).
8. Install the center shroud.
Adjusting the Traction Drive for
2
g027228
3. Cam
Cleaning
Inspecting and Cleaning the
Machine
Service Interval: Before each use or daily
At the completion of operation, thoroughly wash the machine
with a garden hose—without a nozzle—so that excessive
water pressure does not cause contamination and damage to
the seals and bearings.
Make sure that the cooling fins and the area around the
cooling-air intake are kept free of debris.
Important: Cleaning the oil cooler with water promotes
premature corrosion and damage to components, and
compacts debris; refer to
34).
After cleaning, inspect the machine for possible
hydraulic-fluid leaks, damage, or wear to hydraulic and
mechanical components.
Cleaning the Oil Cooler
Service Interval: Every 400 hours
1. Remove the lower shield
1
1. Shield
2. Using a wand, blow compressed air in between the
fan blades (Figure
direction that it entered.
3. Install the shield.
34
Cleaning the Oil Cooler (page
(Figure 44).
Figure 44
2. Oil cooler
44) to force material out from the