Checking The Tire Pressure - Toro Sand Pro 3040 Operator's Manual

Note: This synthetic fluid is not compatible with the
Toro Biodegradable Fluid previously sold. See your Toro
Distributor for more information.
Alternative fluids:
•
Mobil EAL Envirosyn H 46 (US)
•
Mobil EAL Hydraulic Oil 46 (international)
1. Position the machine on a level surface, lower the
attachment, and stop the engine.
2. Clean the area around the hydraulic-reservoir cap to
prevent debris from entering the tank
1. Hydraulic-reservoir cap
3. Remove the cap from the reservoir.
4. Remove the dipstick from the filler neck and wipe it
with a clean rag.
5. Insert the dipstick into the filler neck; then remove it
and check the level of the fluid.
Note: The fluid level must be between the upper
and lower marks (necked-down area) on the dipstick
(Figure 17).
(Figure
Figure 16
16).
1. Upper limit
6. If the fluid level is low, slowly fill the reservoir with the
appropriate hydraulic fluid until the level reaches the
necked-down area on the dipstick.
Note: Do not overfill the reservoir.
7. Install the reservoir cap.
Important: To prevent system contamination,
clean the tops of the containers of hydraulic fluid
before puncturing them. Ensure that the pour
spout and the funnel are clean.

Checking the Tire Pressure

Service Interval: Before each use or daily
Check the tire pressure before operating the machine
18). The correct air pressure in the front and rear tires is as
follows:
•
Treaded tires: 70 kPa (10 psi)
Note: If additional traction is required for blade
operation, reduce the pressure to 55 kPa (8 psi).
•
Smooth tires: 55 to 70 kPa (8 to 10 psi)
19
Figure 17
2. Lower limit
(Figure