Maintenance; Recommended Maintenance Schedule(S) - Toro Sand Pro 3040 Operator's Manual

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.
CAUTION
If you leave the key in the ignition switch, someone could accidently start the engine and seriously injure
you or other bystanders.
Remove the key from the ignition before you do any maintenance.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 8 hours
After the first 20 hours
Before each use or daily
Every 25 hours
Every 100 hours
Every 200 hours
Every 400 hours
Every 800 hours
Every 1,500 hours
Important: Refer to your engine operator's manual for additional maintenance procedures.
Maintenance Procedure
• Torque the wheel lug nuts.
• Change the hydraulic filter.
• Check the level of the engine oil.
• Change the engine oil and filter.
• Check the level of the engine oil.
• Check the level of the hydraulic fluid.
• Check the tire pressure.
• Check the condition of the hydraulic lines and hoses.
• Inspect and clean the machine.
• Check the safety interlock operation.
• Check the cable connections and the level of the battery fluid.
• Torque the wheel lug nuts.
• Grease the machine.
• Change the engine oil and filter.
• Service the air cleaner (earlier in extremely dusty, dirty conditions).
• Replace the air filter.
• Change the hydraulic fluid and filter.
• Clean the oil cooler.
• Replace the spark plugs.
• Replace the fuel filter.
• Decarbon the combustion chamber.
• Adjust the valves and torque head bolts.
• Check the engine speed (at idle and full throttle).
• Drain and clean the fuel tank.
• Replace moving hoses.
• Replace the neutral and seat interlock switches.
22