Communication Command And Function - Panasonic LP-310 Operation Manual

4-2-10 Communication Command and Function

List of Commands
■
Name
1. File number change
2. Arbitrary character string
3. Counter current value
4. Counter reset
5. Status request
6. Marking trigger
7. Marking status transmission
permission
After receiving the "File number change" (FNO), each command is to be executed for the file
number selected with "File number change" (FNO) command.
CHECK
After sending the "File number change" (FNO), "Counter current value" (CNT) and "Counter reset"
(CTR) are acceptable.
CHECK
Details of Commands
■
1. File number change (code: FNO)
(1) File number change
This command changes the file number to the specified file number.
When receiving the file number change command from the RS-232C, only RS-232C is effective for the fol-
lowing file number switching. Besides, after turning OFF the power supply, the control is returned to the
control from the I/O connector.
STX FNO
As for the response data, either normal reception response data or abnormal reception response data is
returned.
Refer to "Response Data" (P.174) for details of both normal reception response data and abnormal reception
response data.
When changing the file number through RS-232C, only RS-232C is effective for the following
file number switching.
CHECK
(2) File number readout
This command reads out the file number under editing.
STX FNO
As for the response data, either normal reception response data or abnormal reception response data is
returned.
180
Code
FNO Switches the file number to the specified file number.
STR Sets the arbitrary character string in ASCII code.
CNT Sets the current value of the counter.
CTR Resets the counter.
STS Calls out the operation status of the laser marker.
MRK Controls the marking.
Sets the permission/prohibition of the sending
MST
response when marking is finished.
S [File number] (3 Bytes)
R (Check sum)
Function Outline
(Check sum)
Delimiter
Page
P. 180
P. 182
P. 183
P. 183
P. 184
P. 184
P. 185
Delimiter