Specifications; General Specifications - Toro Reelmaster 5 Blade Operator's Manual

Specifications

General Specifications

Reel driven by wheels 75T ring gear to 10T pinion through 14T disengaging idler
Reel Drive
gear.
Reduction, Reel to 7.5:1
Wheels
Medium carbon steel, induction hardened blades are welded to seven steel spiders
which are mounted on a 1–1/2" (38 mm) diameter shaft. Tapered roller bearings
Welded Reel
support reel shaft, and an adjusting nut compensates for bearing wear. Diameter of
11 blade reel is 7 inches (17.8 cm). 5 and 7 blade reels are 8" inches (20.3 cm).
Single edge high carbon steel knife attached to a fabricated steel bar; single screw
Bedknife & Bedbar
adjustment on adjustable rod ends.
Bedknife adjusts against reel, with positive adjustment control knob located at
center of bedbar. Adjustment knob contains detent with .001 inch (0.0254 mm)
Bedknife to Reel
movement of bedknife for each indexed position. Pivot point at top of bedbar is
Adjustment
greasable.
16" (0.406 m) diameter pneumatic wheels with tire and tube, studded tread,
stamped steel wheel and cast iron hubs; 16" (0.406 m) diameter semi pneumatic
tires with stamped steel wheels and cast iron hubs; 16" (0.4(06 m) diameter cast
Wheels and Tires
iron wheels – one piece construction; 16" (0.406 m) diameter low profile
semi–pneumatic tires with stamped steel wheels and cast iron hubs; 18" (0.457 m)
semi–pneumatic tires with stamped steel wheels and cast iron hubs.
Differential Disengaging over–running idler gear in gear train.
Width of Cut 30" (0.762 m)
11 Blade – .38 inches (9.5 mm) to 1.25 inches (32 mm) with 16" (0.406 m) dia.
wheel.
7 Blade – .75 inches (19 mm) to 1.75 inches (45 mm) with 16" (0.406 m) dia. wheel.
5 Blade – 1.25 inches (32 mm) to 2.25 inches (57 mm) with 16" (0.406 m) dia.
Height of Cut
wheel
5 Blade – 2.00 inches (50 mm) to 3.00 inches (76 mm) with 18" (0.457 m) dia.
wheel
All adjustment are made in .040 inch increments.
11 Blade w/16" wheels – .58" clip (68 cuts per meter)
7 Blade w/16" wheels – .91" clip (43 cuts per meter)
Frequency of Clip
5 Blade w/16' wheels – 1.28" clip (31 cuts per meter)
5 Blade w/18" wheels – 1.51" clip (26 cuts per meter)
Ribbed cast iron gear cases with tubular cross members. Front cross member
Chassis provides easy attachment for the mower to the Reelmaster Universal and
Reelmaster Transport frames.
3–1/2" (88.9 mm) O.D. Iron pipe running on taper bearings double lip oil seal with
Roller
wear sleeves. Grease fittings provided.
3