Toro Reelmaster 5 Blade Operator's Manual page 15

13. Remove the lower compression spring. Disassemble the
ratchet ring from the ratchet gear ring by removing
three (3) locknuts and prying equally around the ratchet
ring (Fig. 26). Be extremely careful to prevent damage
to the mating surfaces.
Figure 26
1. Lower compression
spring
2. Locknuts
3. Rachet ring
15
14. For removal of the throwout handle (Fig. 27), O–ring
and finger, drive pin from throwout handle. Remove
throwout sleeve by turning counterclockwise.
Figure 27
1. Throwout handle
Note: When replacing O–ring, sleeve must be removed
(Fig. 28). Throwout sleeve need only be loosened for
removal of rachet ring gear.
Figure 28
1. O–ring
15. Lift out the upper compression spring. Remove rachet
gear ring from gear case.
16. Remove roller adjustment bolts and nuts from each side
of roller (Fig. 29).
2. Sleeve