Ed2 Connections Jumpers And Dip Settings - ABB AMVAC Installation And Operation Manual

ED2.0 CIRCUIT BOARD CONNECTIONS, JUMPERS AND DIP SETTINGS
JP1001
PROTECTION TRIP / SECOND TRIP
NORMAL
PROTECTION
JP1019
ADD JUMPER FOR
LOW POWER 33 WATT SET-
TING
42
APPENDIX C
KM1005 (INPUTS)
14 - Under voltage
13 + Under Voltage
12 - Close Blocking
11 + Close Blocking
10
9
8 - 2nd Trip/Protect trip
7 + 2nd Trip/Protect trip
6 - Aux Open/Safe Open
5 + Aux Open/Safe Open
4 - CB Remote Open
3 + CB Remote Open
2 - CB Remote Close
1 + CB Remote Close
KM1004 (OUTPUTS)
14 - Remote Open
13 + Remote Open
12 - Not Ready
11 + Not Ready
10 + Ready
9 - Ready
8 - CB Aux Closed
7 + CB Aux Closed
6 - CB Aux Open
5 + CB Aux Open
4 - CB Closed
3 + CB Closed
2 - CB Open
1 + CB Open
KM1007
PUSH BUTTON ASSY
F IGURE 3 – ED2.0 CIRCUIT BOARD
1VAL050601-MB Rev C
I1001
NOTE: The filter card has wire
jumpers for each binary input.
If the jumpers are left in-
stalled,
Not Used
threshold is as listed in the
Not Used
instruction book.
voltage level required is ap-
proximately
These are typically "not al-
ways" cut for high voltage
board applications and are left
intact for low voltage boards.
I1002 AUX/SAFE OPEN and UV BLOCK OPEN
I1002
the input voltage
If cut the
20V higher.
I1004