Scan Position Auto Adj In Dadf Mode - Canon H1 Service Manual

5
Adjustment > Adjustment Method (DADF) > Scan position auto adj in DADF mode
3) Loosen the screw securing the right hinge.
• A'>B'
Slide the hinge of the DADF forward.
• B'>A'
Slide the hinge of the DADF backward
B'> A'
A'> B'
4) Tighten back the fixing screw you loosened in step 3).
5 Adjustment > Adjustment Method (DADF) > Scan position auto adj in DADF mode
1) Start service mode.
2) On the Service Mode screen, touch the following notations in sequence to bring up the
Adjustment screen:
(LV.1) COPIER > FUNCTION > INSTALL
3) Press [STRD-POS] to highlight.
4) Touch [OK].
CAUTION:
If the machine fails auto adjustment and indicates 'NG', go through the following:
(1) Clean the white roller of the DADF and the stream reading glass of the host
machine; then, execute auto adjustment once again.
(2)If the auto adjustment operation still fails, start service mode, and make adjustments
manually:
(LV.1) COPIER>ADJUST>ADJ-XY>STRD-POS
F-5-12
F-5-13

Scan position auto adj in DADF mode

A press on [OK] will cause the scanner to start a scan; in several seconds,the machine
will end auto adjustment of the read position and indicate 'OK'.
5-11
5-11