5.1.4 Setting the Probe Auto-Cal Schedule
To set the frequency with which the probe Auto-Cal function is run, proceed as follows:
1. From the Probe Configuration screen, tap
the desired probe (see Figure 57 below).
2. Enter the desired number of hours (1 - 730) between Auto-Cal runs.
Save
3. Tap the
button to enter the new value into the moisture.IQ, or tap the
value.
moisture.IQ User's Guide
Auto-Cal Setup
Figure 57: Set Auto-Cal Interval Screen
Chapter 5. Using the Configuration Menu
button to access the Set Auto-Cal Interval screen for
Cancel
button to retain the previous
63