Table of Contents
Advertisement
Chapter 5. Using the Configuration Menu
5.1.1 The Probe Configuration Screen
Probe Config
Tap the
button to open the Probe Configuration screen (see Figure 53 below).
From the Channel vs. Mode grid, you can activate the installed probes on each channel. See Table 8 on page 59 for the
available measurement modes and units. The probe options vary with the Mode selected, as follows:
•
Hygro
- M-Series, MIS Probe (MIS), Constant Value (kH) or M-Series with Computer-Enhanced Response*
(M-CER)
Note: Only M-Series PR probes will work with Computer-Enhanced Response. On the main display, the measurement
label will appear in blue.
•
Temp
- MISP2 (
•
Pressure
MIS
-
,
•
Oxygen
GE01-GE09, % O2 (Percent), PPM O2 (Parts per Million), PPB O2 (Parts per Billion)
-
[see "Configuring Delta F Oxygen Sensor Probes" on page 61 for details.]
•
Aux 1
mA
-
(current),
•
Aux 2
mA
-
(current),
IMPORTANT:
Activating probes that are not physically connected to the meter will result in error messages and slow
performance.
58
Figure 53: Probe Configuration Screen
MIS
M-Series
),
or Constant Value (
Aux 1
Aux 2
,
, or Constant Value (
Volts
(voltage)
Volts
(voltage)
kT
)
kP
)
moisture.IQ User's Guide
Advertisement
Table of Contents
