Table of Contents
Advertisement
2.4
The Data Element Editor (cont.)
As shown in Figure 29 on page 32, the following settings are available for the display:
•
Channel:
Select the channel (1-6) to be displayed.
•
Mode:
Select the measurement type (Hygro, Pressure, Temperature, Oxygen, Aux 1, Aux 2 or Function) to be
displayed.
•
Unit:
Select the units of measure to be displayed.
•
123/Graph:
Toggle between a Numeric and Graphical display.
Note: The error message is only available in numeric mode — not in graphical mode.
•
12.23/1.2E5:
Toggle between Floating Point Decimal and Scientific numeric displays.
•
Slider Bar:
Use the Left and Right arrows to select the number of decimal places for the numeric display.
•
Copy and Paste:
•
Clear All:
Use this button reset the display to the default state.
Note: The current selection for the toggled items is highlighted in blue.
As with all of the moisture.IQ programming screens, tap the
Cancel
button
to keep the previous settings.
2.5 Initial Setup
Before you can obtain accurate measurement data, you must properly configure the moisture.IQ and all attached
probes. This is accomplished by using the Main Menu options along the right side of the measurement display screen.
Simply tap the desired menu item on the touch screen to access that particular menu, and proceed to the appropriate
chapter in this manual for detailed instructions.
After your initial setup is complete, these same menus can be used to program the moisture.IQ with your personal
preferences and to reconfigure the unit whenever there are any changes in your system.
Note: Initially, all menus are locked at startup. After you enter a password, these menus will be unlocked, but will
timeout (and relock) after 15 minutes with no activity.
moisture.IQ User's Guide
Use these buttons to duplicate display settings from one measurement display to another.
Check
button
to save your new settings, or tap the
Chapter 2. Operation
33
Advertisement
Table of Contents
