Download Print this page

Huawei R240D Hardware Installation page 35

Remote units

Hide thumbs Also See for R240D:

Table of Contents

R240D

Hardware Installation and Maintenance Guide

Figure 5-8 Putting the heat shrink tubing onto the bare crimping terminal

Step 3 Put the bare crimping terminal onto the exposed conductor, and ensure that the bare crimping

terminal is in good contact with the insulation of the power cable, as shown in Figure 5-8.

Step 4 Crimp the joint parts of the bare crimping terminal and the conductor, as shown in Figure 5-9.

Figure 5-9 Crimping the joint parts of the bare crimping terminal and the conductor (JG terminal)

Step 5 Push the heat shrink tubing toward the connector until the tube covers the crimped part, and

then use a heat gun to heat the tube, as shown in Figure 5-10.

Issue 03 (2016-01-26)

Huawei Proprietary and Confidential

5 Appendix

Table of Contents