Drive System Maintenance; Calibrating The Traction Pedal; Adjusting The Traction-Pedal Angle; Checking The Rear Wheel Toe-In - Toro Groundsmaster 5900 Operator's Manual

Drive System
Maintenance
Calibrating the Traction
Pedal
Service Interval: Every 1,000 hours—Calibrate the
traction pedal.
Contact your local Toro distributor or refer to the Toro
Service Manual for assistance.
Adjusting the
Traction-Pedal Angle
You can adjust the operating angle of the traction
pedal for your comfort.
1. Loosen the 2 nuts and bolts securing the left side
of the traction pedal to the bracket
Figure 117
1. Traction pedal
2. Pivot the pedal to the desired operating angle
and tighten the nuts
Checking the Rear Wheel
Toe-In
Service Interval: Every 1,000 hours—Check the rear
wheel toe-in.
1. With the rear tires in a straight position, measure
the outside distance (at axle height) at the front
and rear of the rear tires
Note:
The front measurement should be 0
to 3 mm (0 to 0.12 inch) greater than the rear
measurement.
(Figure 117).
2. Mounting nuts and bolts
(Figure 117).
(Figure 118).
1. Outside distance
2. To adjust the toe-in, loosen the clamps at both
ends of the tie rods
3. Rotate the tie-rod to move the front of the tire
inward or outward.
4. Once you achieve the correct toe-in, tighten the
tie-rod clamps.
g009745
80
Figure 118
2. Tie-rod clamps
(Figure 118).
g034932