Toro Groundsmaster 5900 Operator's Manual page 27

Battery Voltage
This display shows both the 12 V and 24 V battery
voltage (Figure 17).
Service-Due Indicator
This display indicates the time until the next regular
service interval.
Note:
After you service the machine, reset the
indicator.
1. Press and hold the far, right button on the
InfoCenter.
Note:
The Main Menu screen appears.
2. Select Service using the 2 buttons on the
left; press the button below the right arrow to
continue.
3. Select Hours and press the button below the
right arrow.
4. Press the button below Reset Hours.
5. Select the Hours for the appropriate next service
time and press the button below the right arrow.
Note:
A check mark appears once the indicator
has been reset.
6. When you are finished, press the button below
the exit icon (picture of an open door) to return
to the main screen, or press cancel to exit.
Audible Alarm (InfoCenter)
The alarm sounds during the following scenarios:
Lowering the deck
•
The engine is not running
•
Any deck is being lowered
Deck is out of float
•
The PTO is requested and qualified
•
Any deck is below the limit, but not floating
Machine sends a request to the InfoCenter
•
The engine sends a red, stop lamp message
Note:
If the alarm stops or if the operator
acknowledges the alarm by pressing any button
on the InfoCenter, then the alarm should stop.
•
Regeneration requested by the engine
•
Any engine fault
•
Any advisory; refer to
31)
•
The engine sends an amber-warning message
•
The fuel level is below 2.2%
InfoCenter Advisories (page
Main Menu
Press and hold the fifth button (far right) on the
InfoCenter to access the main menu.
From the main menu screen, you can access the
Service screen, Diagnostics screen, Settings screen,
or the About screen
Service Screen
If you have an issue that requires use of the Service
screen (i.e., calibrating the traction pedal), contact
your Authorized Toro Service Dealer for assistance.
InfoCenter PIN Entry
1. From the start-up screen, press and hold button
5 until the Main Menu appears
2. Press button 2 until you reach Settings on the
Main Menu screen and press button 4 to select
Settings (Figure
3. From the Settings screen, press button 4 to
select Display
27
(Figure 19).
(Figure
Figure 19
19).
(Figure 20).
19).
G033167
g033167