Checking The Tire And Caster Wheel Pressure; Leveling The Front, Center Deck; Leveling The Winglet Decks To The Front, Center Deck - Toro Groundsmaster 5900 Operator's Manual

B. Using a ratchet wrench or a similar tool,
move the idler pulley away from the pulleys
(Figure 5).
C. Route the belt around the winglet-spindle
pulley and the upper-spindle pulley on the
front deck.
D. Release the idler pulley to put tension on
the belt.
8. Install the winglet-deck cover and secure it with
the rubber latch
Note:
Ensure that you slide the cover under the
front, center deck-cover tabs before inserting it
onto the mounting hooks and post.
9. Repeat this procedure on the other winglet.
1. Cover
2. Rubber latch
3
Checking the Tire and
Caster Wheel Pressure
No Parts Required
Procedure
Check the tire and caster wheel pressure before use;
refer to Checking the Tire Pressure (page 37)
Checking the Caster Wheel Tire Pressure (page
Important:
Maintain pressure in all tires to
ensure a good quality-of-cut and proper machine
performance. Do not underinflate the tires.
Important:
Traction performance, including
tire-slip control, is dependent on the ratio of the
(Figure 6).
Figure 6
3. Front, center deck-cover
tabs
4. Mount hooks
tire size between the front and rear tires. Only use
genuine Toro tires.
4
Leveling the Front, Center
Deck
No Parts Required
Procedure
Note:
Perform this procedure on a flat, level surface.
Refer to Adjusting the Height of Cut (page
1. Rotate the blade on each outer spindle until the
ends face forward and backward.
2. Measure from the floor to the front tip of the
blade.
3. Adjust the 3 mm (1/8 inch) shims on the front
caster fork(s) to match the desired height of cut.
4. Rotate the blades 180° and measure from the
floor to the rear-facing tip of the blade.
g009156
5. Loosen the lower jam nuts on the height-of-cut
chain U-bolt.
6. Adjust the nuts to raise or lower the rear of the
mower deck so that the tips of the rear blades
are 6.35 mm (1/4 inch) to 9.53 mm (3/8 inch)
higher than the front tips.
7. Tighten the jam nuts.
5
Leveling the Winglet Decks
to the Front, Center Deck
No Parts Required
and
Procedure
37).
1. Rotate the blade on each winglet so that it points
side to side.
2. Loosen the bolts and nuts securing the 2
eccentric spacers to the winglets
19
38).
(Figure 7).